Final Table Assembly

NOTE: Letting the blade teeth hit the blade guides while using the band saw will ruin the blade° The set of the teeth and the sharpened edge of the teeth would be damaged Proper adjustment of the upper and lower blade guide assemblies wil! prevent this from happening

5 Adjust the blade guides last Use a 1/8" hex wrench to turn the blade guides in or out to where they just clear the side of the blade Do this for all four guides

NOTE: There is a patch on the blade guide threads that makes them difficult to turn This is necessary to prevent rotation of the guides during operation of the

saw

6Reinstall blade guard and tighten screw

7 Close the front cover of the saw

WARNINGI Never start the saw with the cover

pen. Thrown blades can cause injury,

1 Close the front cover of the band saw and snap in place

2, Locate a 1/4-20 x 5/8 truss head screw, and a 1/4- 20 wing nut in loose parts Insert screw into hole in table top as illustrated

3 From the underside of the table, install wing nut onto the truss head screw and tighten finger tight This will keep the table flat and in alignment

unplug before making any adjustments. WARNING:Turn off saw, remove switch key and

ALIGNING THE TABLE SQUARE

TO THE BLADE

1Loosen the upper slide lock knob and position the

guide assembly all the way up Tighten the lock knob

2Loosen table lock knob

3Place a small square on the table beside the blade as illustrated,

4Holding the teft edge of the table (near the zero stop set screw), tilt the table up or down to align tabte 90 degrees to blade (0 degree position)

Tighten lock knob

5Adjust the zero stop set screw using a 1/8" hex wrench until the set screw just touches the frame

6Check squareness of blade to table Make readjustments if necessary

Saw

Biade

Blade

Guides

,_.._ Truss Head

Screw

Nut

Combination

Zero Stop

Screw