Save This Manual
Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for future reference.
Important SAFETY
Information
In this manual, on the labeling, and all other information provided with this product:
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will result
in death or serious injury.
WARNING indicates a hazardous
situation which, if not avoided, could result in death or serious injury.
CAUTION, used with the safety alert
symbol, indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
NOTICE is used to address practices not related to personal injury.
CAUTION, without the safety alert
symbol, is used to address practices not related to personal injury.
Safety Warnings and
Precautions
WARNING: When using helmet, basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment.
The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Read all instructions before using
this helmet!
1.Do not use the Welding Helmet if the lens is cracked, if the lens or sensors are dirty, or if the lens or front retaining frame is loose.
2.Keep work area clean. Cluttered areas invite injuries.
3.Observe work area conditions. Do not use welding helmets in damp or wet locations. Do not expose to rain. Keep work area well lit. Do not use auto- darkening helmets in the presence of flammable gases or liquids.
4.Keep children away. Children must never be allowed in the work area. Do not let them handle this helmet.
5.Store idle equipment. When not in use, helmets must be stored in a dry location to inhibit rust. Always lock up helmets and keep out of reach of children.
Page 2 | For technical questions, please call |
| Welding Helmet |