Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
SAFETY
Lens and Helmet Maintenance
Replace the Front Lens Cover if it is damaged | Figure F |
(cracked, scratched, soiled or pitted). |
|
1. To Replace the Cover:
a.Remove the Front Lens Cover by gently pulling up the central part of the Lens. See Figure F. If the unit has a frame over
the front of the lens, lift up on the tab at the bottom of the frame to access the lens cover.
b.Remove the protection film from both sides of
the new Lens if it comes with a film covering. Place the new Lens into place by bending it slightly and sliding it between the tabs at each side of the lens until it snaps into place.
c. Make sure that the Lens is securely installed. If the unit has a frame, make sure that the frame is snapped securely into place.
2.Clean the Filter Lens with a clean
3.Do not immerse the lens in water or any other liquid. Do not use abrasives, solvents or oil based cleaners.
4.Do not remove the
5.Storage temperature:
SPECIFICATIONS
OPERATION
MAINTENANCE
Item 67854 | For technical questions, please call | Page 9 |