Emerson CF1ORB01 owner manual Assembly Instructions

Assembly Instructions

1.Remove the fan motor and housing assembly from styrofoam packaging and position it so that the top of the motor is facing you.

2.Remove the hanger ball from the downrod by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 9.

PIN

HANGER BALL

DOWNRODSETSCREW

Figure 1

3.Separate, untwist and unkink the three motor leads. Route the motor leads through the downrod and seat the downrod in the motor coupling (Figure 2).

NOTE: If your ceiling height is nine feet or higher, you may use the 18-inch downrod, along with the downrod trim and decorative bulb. If your ceiling height is between eight and nine feet, you must use the shorter 4-1/2” downrod.

!WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 3) could result in the fan falling.

5.Install the setscrew (supplied) in the motor coupling (Figure 3). While pulling up on the downrod, tighten the setscrew using the setscrew wrench (supplied).

NOTE: The setscrew must be properly installed as described above, or fan wobble could result.

MOTOR LEADS (BLACK, WHITE, AND BLUE)

DOWNROD

FAN MOTOR AND

HOUSING ASSEMBLY

SETSCREW

WRENCH

DOWNROD

HAIRPIN

CLIP

SETSCREW

MOTOR

COUPLING

CLEVIS PIN

WHITE LEAD
CONNECTED	DOWNROD
BROWN LEADS
HAIRPIN	CLEVIS PIN
CLIP
	MOTOR
CONNECTED	COUPLING
RED LEADS

Figure 3

6.Screw two 1” threaded studs (supplied) into the motor (Figure 4). Leave approximately 7/8” of the stud extending above the motor. Slide the motor cover over the downrod and rotate the cover until the threaded studs protrude; install two lockwashers and knurled knobs (supplied) to secure the cover.

NOTE: Make sure the connected red leads, the connected brown leads, and the white lead are completely inside the motor cover and not pinched between the motor cover and the motor.

KNURLED KNOB

Figure 2

4. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 3). (Pin and clip are supplied in loose parts bag.) The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull up on the downrod to make sure the clevis pin is properly installed.

LOCKWASHER

Figure 4

4

MOTOR COVER

1" THREADED STUD 7/8"

MOTOR