Emerson CF935AB00, CF935BC00, CF935WB00, CF935OB00 Unpacking Instructions, Up to 50 ft 50-100 ft

This Manual Is Designed to Make it as Easy as Possible for

You to Assemble, Install,

Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One 1/4” blade screwdriver	One wire stripper
Three wire connectors (supplied).

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of following size

:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 6). If you feel you do not have enough wiring knowledge or experi- ence, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or acces- sories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

1.Check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor assembly

b.One switch housing assembly

c.Five fan blades

d.One ceiling cover

e.Five blade flanges

f.One hanger ball/downrod assembly

g.One hanger bracket

h.One coupling cover

i.One loose parts bag containing:

1.Sixteen 3/16-24 x 1/4” slotted Phillips blade screws

2.Sixteen blade washers

3.Eleven1/4-20 x 1/2” Phillips oval head flange screws

4.One wood pendant

5.One coupling

6.Three wire connectors

7.Two threaded studs

8.Two lockwashers

9.Two knurled knobs

10.One clevis pin

11.One hairpin clip

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retail- er or catalog outlet for replacement before pro- ceeding.

2.Remove the fan assembly from the protective plas- tic bag. Place the fan assembly into the upper foam pad with the top of the motor facing up.

The upper foam pad serves as a holder for the fan during the first stages of assembly.

LOOSE

PARTS

BAG

		FAN MOTOR
		ASSEMBLY
		HANGER BALL/
		DOWNROD
		ASSEMBLY
		HANGER
		BRACKET
BLADE		SWITCH CUP
FLANGES
		ASSEMBLY
CEILING	COUPLING
	COVER
COVER		FAN
		BLADES

3