Wall Control Installation

The fan speed control is designed to operate only one ceiling fan, and not an accessory light kit. This wall control is rated for 1.2 amps at 120 volts. To avoid erratic speeds and possible damage to your ceiling fan, use this control only with the fan pull chain switch set to its high speed setting.

NOTE: The “0” position is OFF. The four fan speeds are selected by sliding the bar to the other four speed positions (“1”, “2”, “3” and “4”).

1.Before disconnecting power, ensure that the fan is set at the highest speed.

NOTE: Electric connections should be in accordance with the National Electrical Codes and all Local Codes. Before starting, disconnect power to the circuit at the fuse box or circuit breaker panel.

2.Remove the faceplate and screws from the existing wall switch. Pull switch out from wall outlet box.

3.Disconnect wire from existing fan wall switch (Figure 14).

4.Slide the fan control in the OFF position (0).

5.Connect one BLACK wire from the fan speed control to the fan/motor lead with a wire connector (provided). (Figure 15.)

6.Connect the other BLACK wire from the fan speed control to the 120VAC hot wire with a wire connector (provided).

NOTE: Use wire connectors (supplied) to secure electrical connections.

7.Attach the fan speed control to the wall outlet box with two 6-32 x 3/4” screws (provided).

8.Position the faceplate (provided) onto the speed control. Using the two 6-32 x 1/4” screws, screw the faceplate and speed control to the wall outlet box (Figure 16).

9.Restore power at the main fuse box or circuit breaker panel.

WALL

SWITCH OUTLET

FACEPLATE	BOX

Figure 14

		STANDARD ON-OFF
		WALL LIGHT SWITCH
TO	TO FAN LIGHT	TO
NEUTRAL	TO FAN MOTOR LOAD	TO
	TO FAN MOTOR LOAD	120-VOLT
		LIGHT
		SUPPLY
		HOT
	MOTOR LOAD
	1.2 AMP MAXIMUM
	BLACK
4	BLACK
3	BLACK
2
1
0
		TO 120VAC
Figure 15		SOURCE HOT
Figure 15

OUTLET BOX

FAN SPEED

CONTROL

4 3 2 1 0

6-32 x 3/4"

SCREW (2)

FACEPLATE

6-32 x 1/4" SCREW (2)

Figure 16

9	U.L. Model No.: CF901