5.To replace the Gun Liner: Disconnect the Gun’s Power Cable from the Welding machine. Remove the Nozzle, Contact Tip, Adapter, Gas Diffuser, and Wire Outlet Guide. Then, remove the old Liner. Lay the Gun’s Power Cable out straight before installing a new Liner. Blow out the Gun Casing with compressed
air. Install and tighten the new Liner. Cut Liner off 3/4” from the Head Tube (3/8” for aluminum). Then reinstall the Wire Outlet Guide, Gas Diffuser, Adapter,
Contact Tip, and Nozzle. (See Figure P.)
REMOVE NOZZLE (100A),
CONTACT TIP (90A),
ADAPTER, GAS DIFFUSER,
WIRE OUTLET GUIDE.
SWAN NECK (1A)
REMOVE OLD
LINER (130A).
BLOW OUT
GUN CASING.
LAY GUN POWER CABLE (40A) |
|
OUT STRAIGHT BEFORE |
|
INSTALLING NEW LINER. | FIGURE P |
SKU 91146 | For technical questions, please call | PAGE 24 |