Husqvarna MC1809H, MC1805B, MC1809R, MC1813H, MC1813R Assembly, Remove the Blade 2E before transport

INDICATION

MANDATORYINFORMATION INSTRUCTION

WARNINGPROHIBITION

2

•

•

Assembly

The Handle must be attached. Place Handle in position and securely tighten Knobs.

Check the engine oil level. Service before using. Refer to the engine operation manual for detailed information.

These signs will give advice for your safety

Before leaving our factory every machine is thoroughly tested.

Follow our instructions strictly and your machine will give you long service in normal operating conditions.

1 Features

Use: Wet sawing of old and new concrete and asphalt.

Tools: Diamond blades — water cooled, Ø: 10", 12", 14", 18" and 20" with Arbor Ø - 1"

(For information, contact your Target supplier)

CUTTING DEPTHS

	MAXIMUM	MC18
BLADE SIZE	BLADE DEPTH	MAXIMUM DEPTH
	(To Collar)	(To Depth Stop)
10" (250mm)	2 3/4" (68mm)	2 1/2" (62mm)
12" (300mm)	3-3/4" (93mm)	3-1/2" (87mm)
14" (350mm)	4-3/4" (118mm)	4-1/2" (112mm)
18" (450mm)	6-3/4" (164mm)	6-1/2" (158mm)

Before starting up the machine, make sure you read this entire manual and are familiar with the operation of this machine.

The working area must be completely clear, well lit and all safety hazards removed.

The operator must wear

protective clothing appropriate to the work he is doing.

Any persons not involved in the work, should leave the area.

Use only blades marked with a maximum operating speed greater than the bladeshaft speed.

3 General Instructions

Remove the Blade (2E) before transport.

WARNING: DO NOT operate without the proper blade guard over the Blade! (2E)

WARNING: DO NOT operate the saw with the front of the Blade Guard (2H) raised!

WARNING: Blade exposure CANNOT exceed 180 degrees when operating!

•The Front Pointer must be checked for alignment with the Blade (2E). It must be in line with the Blade (2E) mounted on the Blade Shaft (2I).

•For WET SAWING, be sure the water jets in the blade guard water tubes are open and that each side of the Blade (2E) has an adequate supply of water. Test the water supply for pressure and quantity (flow) before starting to saw.

WATER FLOW from 2-1/2 to 5 gallons of water per minute MUST flow over the blade to properly cool it and to get maximum blade life. DO NOT use conventional (wet) diamond blades without water!

•Saw only as deep as the specifications and job conditions require. Sawing excessively deep is wasteful–avoid it! Step cut in increments of 2 inches (50 mm) for best results.

•Saw in a straight line. Mark the cutting line clearly so the saw operator can follow the line without difficulty. The saw should NOT be twisted from side to side try- ing to force the blade back on the line.

14