Husqvarna K 760 manual KEY to Symbols, Symbols on the machine, Explanation of warning levels

Page 2

KEY TO SYMBOLS

Symbols on the machine:

WARNING! The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Wear personal protective equipment. See instructions under the heading ”Personal protective equipment”.

WARNING! Dust forms when cutting, this can cause injuries if inhaled. Use an approved breathing mask. Avoid inhaling petrol fumes and exhaust fumes. Always provide for good ventilation.

WARNING! Kickbacks can be sudden, rapid and violent and can cause life threatening injuries. Read and understand the instructions in the manual before using the machine.

WARNING! Sparks from the cutting blade can cause fire in combustible materials such as: petrol (gas), wood, dry grass etc.

You will find the following labels on your power cutter:

The Emissions Compliance Period referred to on the Emission Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal emissions requirements.

The engine exhaust from this product contains chemical known to the State of California to cause cancer, birth defects or other reproductive harm.

Other symbols/decals on the machine refer to special certification requirements for certain markets.

Explanation of warning levels

The warnings are graded in three levels.

WARNING!

!

WARNING! Used if there is a risk of serious

injury or death for the operator or damage to

the surroundings if the instructions in the

 

manual are not followed.

CAUTION!

!

CAUTION! Used if there is a risk of injury to

the operator or damage to the surroundings

if the instructions in the manual are not

 

followed.

NOTICE!

NOTICE! Used if there is a risk of damage to materials or the machine if the instructions in the manual are not followed.

2 – English

Image 2
Contents 760 Explanation of warning levels KEY to SymbolsSymbols on the machine Contents Dear customer FeaturesPresentation What is what on the power cutter K 760? PresentationGeneral MACHINE´S Safety EquipmentStop switch Throttle lockoutChecking the vibration damping system Vibration damping systemMuffler Inspecting the mufflerCutting Blades Abrasive bladesTransport and storage Diamond bladesToothed blades Fitting the cutting blade Assembling and AdjustmentsChecking the drive shaft and flange washers Guard for the bladeGasoline Fuel HandlingFuel Two-stroke oilLong-term storage FuelingOilGuard K760 OilGuard Protective equipment General safety precautionsOperating Work area safety Basic working techniquesKickback Starting Starting and StoppingBefore starting Stopping Functional inspection MaintenanceMaintenance schedule Cleaning Functional inspectionReplacing the drive belt Adjusting the idle speedCarburetor Tensioning the recoil spring StarterChanging a broken or worn starter cord Changing a broken recoil springDrive gear, clutch Fuel systemAir filter Technical Data Cutting equipmentFederal Emission Control Warranty Statement Your Warranty Rights and ObligationsPage ´z+UC¶5h¨ Page Original instructions 1153355-95 ´z+UC¶5h¨ ´z+UC¶5h¨