Emerson BP7251 warranty Supply Wires

PIN

HANGER BALL

DOWNROD

CEILING COVER

Figure 9A

17.Screw in four 60-watt (maximum) candelabra base lamps in the housing sockets (Figure 10A). Grasp the sockets and pivot them until the lamp bulbs are even with the top of the housing as shown. This will provide the optimum lighting effect.

TOP OF

HOUSING

SOCKET

CANDELABRA

BASE LAMP

Figure 10A

!WARNING

The fan must be hang with at least 7’ of clearance from floor to blades (Figure 11A).

AT LEAST

7'

!WARNING

Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.

OUTLET

BOX

TWO SCREWS
SUPPLIED WITH	HANGER
OUTLET BOX
	BRACKET

Figure 12A TAB

19.Carefully lift the fan and seat the hanger ball/downrod assembly on the hanger bracket that was just attached to the outlet box (Figure 13A). Be sure the groove in the box is lined up with tab on the hanger bracket (Figure 12A).

!WARNING

Failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard.

NOTE: CEILING COVER,
SUPPLY WIRES AND	OUTLET
FAN WIRES OMITTED
	BOX
FOR CLARITY.

	HANGER
	BRACKET
Figure 13A	HANGER BALL/
	DOWNROD ASSEMBLY

!WARNING

Figure 11A

FLOOR

To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and the hanger bracket.

!WARNING

The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs.

18.Securely attach the hanger bracket to the outlet box using the two screws supplied with the outlet box (Figure 12A).

!WARNING

To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked acceptable for fan support, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.

!WARNING

To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must be grounded for safe operation.

20.Screw two 1-1/4" threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 14A).

7