Generac 005797-0 (XG7000) Emission Related Parts MAY Include the Following if Equipped

Page 21

Warranty

EMISSION CONTROL SYSTEM WARRANTY

Emission Control System Warranty (ECS warranty) for equipment using small spark-ignited engines:

(a)Applicability: This warranty shall apply to equipment that uses small off-road engines. The ECS Warranty period shall begin on the date the new equipment is purchased by/delivered to its original, end-use purchaser/owner and shall continue for 24 consecutive months thereafter.

(b)General Emissions Warranty Coverage: Generac warrants to the original, end-use purchaser/owner of the new engine or equipment and to each subsequent purchaser/owner that the ECS when installed was:

(1)Designed, built and equipped so as to conform with all applicable regulations; and

(2)Free from defects in materials and workmanship which cause the failure of a warranted part at any time during the ECS Warranty Period.

(c)The warranty on emissions-related parts will be interpreted as follows:

(1)Any warranted part that is not scheduled for replacement as required maintenance in the Owner's Manual shall be warranted for the ECS Warranty Period. If any such part fails during the ECS Warranty Period, it shall be repaired or replaced by Generac according to Subsection (4) below. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(2)Any warranted part that is scheduled only for regular inspection as specified in the Owner's Manual shall be warranted for the ECS Warranty Period. A statement in the OwnerÂ’s Manual to the effect of "repair or replace as necessary" shall not reduce the ECS Warranty Period. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(3)Any warranted part that is scheduled for replacement as required maintenance in the Owner's Manual shall be warranted for the period of time prior to first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part shall be repaired or replaced by Generac according to Subsection (4) below. Any such emissions- related part repaired or replaced under the ECS warranty shall be warranted for the remainder of the period prior to the first scheduled replacement point for that part.

(4)Repair or replacement of any warranted, emissions-related part under this ECS Warranty shall be performed at no charge to the owner at a Generac Authorized Warranty Service Facility.

(5)Notwithstanding the provisions of subsection (4) above, warranty services or repairs must be provided at Generac Authorized Service Facilities.

(6)When the engine is inspected by a Generac Authorized Warranty Service Facility, the purchaser/owner shall not be held responsible for diagnostic costs if the repair is deemed warrantable.

(7)Throughout the ECS Warranty Period, Generac shall maintain a supply of warranted emission-related parts sufficient to meet the expected demand for such parts.

(8)Any Generac authorized and approved emission-related replacement parts may be used in the performance of any ECS warranty maintenance or repairs and will be provided without charge to the purchaser/owner. Such use shall not reduce Generac ECS Warranty obligations.

(9)Unapproved, add-on, modified, counterfeit and/or "grey market" parts may not be used to modify or repair a Generac engine. Such use voids this ECS Warranty and shall be sufficient grounds for disallowing an ECS Warranty claim. Generac shall not be held liable hereunder for failures of any warranted parts of Generac equipment caused by the use of such an unapproved, add-on, modified, counterfeit and/or "grey market" part.

EMISSION RELATED PARTS MAY INCLUDE THE FOLLOWING (IF EQUIPPED):

1)

FUEL SYSTEM

3)

FUEL METERING SYSTEM

 

A. FUEL TANK

 

A. CARBURETOR AND INTERNAL PARTS

 

B. FUEL CAP

 

B. PRESSURE REGULATOR

 

C. FUEL LINE

4)

AIR INDUCTION SYSTEM

 

D. FUEL LINE FITTINGS

 

A. INTAKE MANIFOLD

 

E. CLAMPS*

 

B. AIR FILTER

 

F.

PRESSURE RELIEF VALVES*

5)

IGNITION SYSTEM

2)

EVAPORATIVE CONTROL SYSTEM

 

A. SPARK PLUGS

 

A. CARBON CANISTER

 

B. IGNITION COILS / MODULE

 

B. CANISTER MOUNTING BRACKETS

6)

AIR INJECTION SYSTEM

 

C. CARBURETOR PURGE PORT

 

A. PULSE AIR VALVE

 

D. CONTROL VALVES*

7)

EXHAUST SYSTEM

 

E. VAPOR HOSES

 

A. CATALYST

 

F.

PURGE VALVES

 

B. THERMAL REACTOR

 

G. LIQUID / VAPOR SEPARATOR

 

C. EXHAUST MANIFOLD

 

H. VACUUM CONTROL DIAPHRAGMS*

 

 

*NOTE: As they relate to the Emission Control System.

Part 2

Part No. 0H1913 Rev. A 01/09

19

Page 20 Page 22
Image 21
Page 20 Page 22
Contents XG Series 6,500-8,000 Watt Portable Generator Table of Contents Introduction Indicates a hazardous situation or action which, if not• Never operate in an enclosed area or indoors Exhaust & Location Hazards Safety Rules• Keep a fire extinguisher near the generator at all times 0SGEXMSRWGeneral Information • 2 1 Quart SAE 30 Oil BottlesWheel kit is not intended for over-the-road use – Generator Locations OperationMaintenance Rubber boot over the starter terminal. See FigureBattery shipped with the generator has been fully charged Hourmeter tracks hours of operation for scheduled– Generator Ground Location -67 – Neutral to Frame Ground– Oil Level To Run position • Install fuel cap and wipe up any spilled gasolineService Air Cleaner MaintenanceCharge Replace Spark Plug Every SeasonDisplacement Use the following instructions to change the oil Do not use a garden hose to clean generator. Water can• Store the unit in a clean, dry place Avoid spray from spark plug hole when cranking engine• Replace the spark arrestor and secure with the clamp 667836 762 74%6– Battery Removal Battery ServiceTroubleshooting Page MANUFACTURER’S Warranty Coverage WarrantyEmission Related Parts MAY Include the Following if Equipped BOX 8 Waukesha, WI Ph 888 Generac 436-3722 Fax 262 Warranty Schedule
Top Page Image Contents