Generac 005797-0 (XG7000), 005800-0 (XG8000) General Information, • 2 1 Quart SAE 30 Oil Bottles

Page 6

General Information

•Remove all packaging material.

•Remove separate accessory box.

•Remove carton off the generator.

Check all contents (Figure 1). If any parts are missing or damaged locate an authorized dealer at 1-888-775-6937.

Contents include:

 

 

• 2 – Axle Pins

•

Oil Filter

• 2 – Wheel Spacers

•

Air Filter

• 2 – Hair Pins

•

Spark Plug

• 2 – Wheels

•

Spark Plug Wrench

• 1

– Frame Foot

•

Shop Towel

• 2

– Frame Bolts

• 2 – Frame Washers

• 2

– Vibration Mounts

•

Oil Funnel

• 4

– Flange Nuts

12 Volt Adaptor Plug Charger

•2 – 1 Quart SAE 30 Oil Bottles

Figure 1 – Accessory Boxes

•Refer to Figure 2 and install the wheel kit and frame foot as follows:

•Slide the Axle Pin through the Wheel, Wheel Spacer (Washer) and the Frame.

•Install the Hair Pin to the Axle Pin to secure the wheel. Repeat for the opposite side.

•Secure the Vibration Mounts to the Frame Foot with the included locking nuts.

•To install the Frame Foot, install the Frame Bolts though the Frame Washers, Frame and Frame foot. Secure with the locking nuts.

Figure 2 – Wheel and Foot Assembly

%77)1&0)

*6%1)

*338

7)'96);,))0 %2(%<0);-8, ,%-64-2

*6%1)

 

;,))074%')6

*6%1)

;%7,)6

;%7,)6

&308

 

Read entire Owner's Manual before attempting to assemble or operate the generator. The generator requires some assembly prior to using it. If problems arise when assembling the generator, please call the Generator Helpline at 1-888-775-6937.

*0%2+)

298

70-()%<0)

8,639+,;,))0

%2(;,))0

74%')6

The wheel kit is designed to greatly improve the portability of the generator. You will need the following tools to install the wheel kit: Pliers, 1/2" (13mm) wrench and a socket wrench with a 1/2" (13mm) socket.

NOTE:

The wheel kit is not intended for over-the-road use.

4

Image 6
Contents XG Series 6,500-8,000 Watt Portable Generator Table of Contents Introduction Indicates a hazardous situation or action which, if not• Never operate in an enclosed area or indoors Safety Rules Exhaust & Location Hazards0SGEXMSRW • Keep a fire extinguisher near the generator at all timesGeneral Information • 2 1 Quart SAE 30 Oil BottlesWheel kit is not intended for over-the-road use Operation – Generator LocationsBattery shipped with the generator has been fully charged Rubber boot over the starter terminal. See FigureMaintenance Hourmeter tracks hours of operation for scheduled– Generator Ground Location – Neutral to Frame Ground -67– Oil Level • Install fuel cap and wipe up any spilled gasoline To Run positionCharge MaintenanceService Air Cleaner Replace Spark Plug Every SeasonDisplacement Do not use a garden hose to clean generator. Water can Use the following instructions to change the oil• Replace the spark arrestor and secure with the clamp Avoid spray from spark plug hole when cranking engine• Store the unit in a clean, dry place 667836 762 74%6Battery Service – Battery RemovalTroubleshooting Page Warranty MANUFACTURER’S Warranty CoverageEmission Related Parts MAY Include the Following if Equipped Warranty Schedule BOX 8 Waukesha, WI Ph 888 Generac 436-3722 Fax 262