Instruction Sheet
MODEL SB1269
TAPER ATTACHMENT
This taper attachment is heavy! Get assistance when installing this accessory on the lathe. Wear heavy duty leather boots for foot and toe protection, and keep hands and fingers away from all pinch points. Ignoring this warning can lead to a severe crushing injury or finger amputation!
Specifications
•Fits Lathe Models...14" x 40" SB1012, SB1013
.................................16" x 60" SB1014, SB1015
| ................................ 16" x 40" SB1037, SB1038 | |
• | Taper Per Inch Range | |
• | Minor Inch Scale Divisions | 0.010" |
• | Major Inch Scale Divisions | 0.020" |
• | Taper Angle Range | |
• | Minor Taper Scale Divisions | 1⁄2° |
• | Major Taper Scale Divisions | 1° |
• | Maximum Length of Taper | 12⁜1⁄4" |
• | Taper Adjustment Knob | Yes |
• | Construction | Steel |
• | Unit Weight | 78 lbs |
• | Origin | Taiwan |
If you need help with your new item, contact us at: (360)
Introduction
The Model SB1269 taper attachment was designed to fit onto a series of South Bend lathes. Shown in Figure 1, is a Model SB1012 lathe that is fitted with the Model SB1269 taper attachment.
Taper attachment installed
on rear side of lathe
Figure 1. Model SB1269 installed.
This taper attachment mounts quickly to the back bed way of your lathe. Accurate tapers of up to 12" can be produced without repositioning the attachment or having to offset the talstock.
The Model SB1269 features scales at both ends, reading
Another feature is the ability to use the taper attachment without disengaging the cross slide nut. This design allows the taper attachment to be functional at any time by simply tightening the two