Installation
1.Carefully place the Lathe on a sturdy, level work table with sufficient light.
2.Use appropriate hardware (not included) in the mounting holes of the lathe base, to properly secure the lathe. The work table must also be properly mounted to the floor.
3.Before operation, verify that the slide, worktable, and spindle can move, and are not locked in place.
4.Clean machine with nonflammable solvent and oil the machine according to the lubrication requirements (see Lubrication section) before running the machine.
Operation
This 8 x 12 inch Lathe is capable of machining metal and nonmetallic stock by cutting, drilling, and milling. It can cut circular surfaces, both inside and out, cones, mill planes or grooves, and other cutting functions depending on the tools used. It can also create SAE
and metric threads. |
| B |
|
|
Controls |
| A |
|
|
| E | F |
| |
|
| H | ||
|
|
| ||
|
|
|
| I |
|
|
|
| |
|
|
|
|
|
D C G
NOTE: The Splash Guard shown in the photo above is not included. It can be ordered using SKU 26962.
| ITEM | NAME | USAGE | ASSY NO. |
|
|
|
|
|
|
|
| A | Reversing Switch | Change rotation direction of the spindle | 200 |
|
|
|
|
|
|
|
| B | Master Switch | Turn machine power On and Off | 200 |
|
|
|
|
|
|
|
| C | Turn Lever | Moves saddle transversely | 500 |
|
|
|
|
|
|
|
| D | Turn Lever | Moves saddle longitudinally | 600 |
|
|
|
|
|
|
|
| E | Straight Lever | Clamps the square tool rest | 400 |
|
|
|
|
|
|
|
| F | Straight Lever | Moves the square tool rest carriage longitudinally | 400 |
|
|
|
|
|
|
|
| G | Straight Lever | Controls apron clasp nut | 600 |
|
|
|
|
|
|
|
| H | Straight Lever | Controls tailstock sleeve | 300 |
|
|
|
|
|
|
|
| I | Turn Lever | Moves tailstock sleeve longitudinally | 300 |
|
|
|
|
|
| 5 |
SKU 44859 |
| 07h | Page |