Manhattan Computer Products ST100 Install Menu, Configuring Your Antenna, LNB Power

TV Settings

TV Standard: Select the output for your TV. Example: for UK select PAL I. If your TV supports ‘Auto Sensing’ then select Auto.

Screen Format: Select the picture aspect ratio for your TV.

Video Output: Select signal output for your TV. If the teletext function on your TV does not work when viewing channels from other sources such as terrestrial TV, select COMP mode.

UHF Channel: Select a UHF channel between 21 – 69.

STORE: After above settings move to store and press OK key.

Time Settings

The front display in standby mode, and the channel banner in user mode will indicate the time.

Year / Month / Date / Hour / Minutes: Press VOL up / down to set.

STORE: After above settings move to store and press OK key.

Event Timer

You can program up to 10 events for the receiver to switch on automatically.

Event No: Select event number you are setting.

Timer: To turn on an event, select VCR SCART.

TV / Radio: Select TV or Radio mode.

The receiver will automatically switch on and off at the stored times for

Satellite: Select name of the satellite.

each event. After the time has lapsed, it will reset that event to Off. Channel: Press OK and select the channel you want to record.

Month / Date: Select month and date the event is to come on.

On Time / Off Time: Using 0-9 keys enter the time.

STORE: After above settings move to store and press OK key

To reset the receiver to factory default settings, select Master Reset and press OK. A PASSWORD window will appear. Using 0-9 keys enter your password and the WARNING message will appear. Press OK to reset or EXIT to abandon resetting.

INSTALL Menu

CONFIGURING YOUR ANTENNA

Your receiver is preset to UNIVERSAL LNB for all LNB numbers (1-50). If you are using one Universal LNB, then you do not need to change any settings. You can re-program these when using more then one LNB.

LNB No: Select reference number.

LNB Type: Select type and press OK to configure LO settings.

LO SETTINGS:

 Universal ---Low 9750, High 10600, 22 KHz tone is automatic.  Single 1 ----10750, 22 KHz tone is selectable.

 Single 2 ----10700, 22 KHz tone is selectable.

 Single 3 ----11300, 22 KHz tone is selectable.

 C Band -----5150, 22 KHz tone is selectable.

 Wide -------Low 9750, High 10750, 22KHz tone is selectable

You can change the LO figure for any of these settings to suit your LNB

LNB POWER

 V / H -----Both polarities are selected. V = Vertical 14V. H = Horizontal 18 V

 14V Skew On -----14V vertical or lower band for Wideband LNB

 18V Skew On -----18V horizontal or higher band for Wideband LNB

 Off ------No power output.

22KHz Tone: When using other than Universal LNB, you can select tone status.

DiSEqC: When using more than one LNB for fixed installation with a DiSEqC switch. See following example.

6