Manhattan Computer Products ST100 Remote Control Functions, Operation in Programming Mode

F13: IRDETO CARD SLOT (For Models with embedded Irdeto) Insert your smart card into this slot.

REMOTE CONTROL FUNCTIONS

We recommend that you familiarize yourself with the remote control handset prior to installing the receiver.

OPERATION IN PROGRAMMING MODE

The menus are designed to assist you from the moment you switch on the receiver. Follow the help messages at the bottom of the menu.

INSTALLATION

For digital quality picture, connect the receiver to your TV using a fully wired SCART lead. If using the UHF TV OUT connector then follow below step.

TUNING YOUR TV TO UHF OUTPUT

Connect your TV using a UHF (co-axial) lead and switch on the receiver. After initialising the digit LED (F2) will display “NOCH”. The receiver has been factory set to channel 64. Select a spare channel on your TV and tune it until you see the following OSD Settings menu. Finally store the settings on your TV.

MAIN MENU

Press the MENU key to configure all your settings.

To select, press CH up / down or VOL up / down key. To enter, press

OK key.

Language: Select the required OSD language.

Transparency: Adjust transparency of channel banner and channel browser.

Info-Display:Select display time of the channel banner. If you select On it will remain on until exit key is pressed.

Audio Lang / Subtitle Lang: Select default language. This sets all channels to that language

Screen Saver: Select time to turn ON screen saver in radio mode. After the seconds have lapsed, the screen will change to revolving radio banner. STORE: After above settings move to store and press OK key.

5