Emerson CF945WB, CF945PW, CF945HTW, CF945AB owner manual

16.Rotate the motor hub until the flange screw holes are visible through the slots in the switch housing plate. Loosely attach one blade assembly to the motor hub using two 1/4-20 x 1/2” flange screws (Figure 13). Make sure the screws are NOT tightened. Repeat this procedure for the other four blade assemblies.

!WARNING

To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.

1/4-20 x 1/2" FLANGE SCREWS
(INSTALL THROUGH SLOTS	MOTOR
IN SWITCH HOUSING PLATE)	HUB

BLADE

FLANGE

SWITCH HOUSING

PLATE

Figure 13

17.The blade flanges have an interlocking feature that must be fully engaged before tightening the screws. Make sure all the flanges are properly engaged and then tighten the flange screws. If one of the flanges does not seat properly on the motor hub, loosen the adjacent flange screws, re-engage and reseat the flanges, then tighten the screws again.

18.Engage the motor connector with the connector in the remote control receiver (Figure 14). The two connectors are keyed and must be mated correctly before they can be engaged.

MOUNTING

SCREW (3)

SWITCH HOUSING

PLATE

MOTOR CONNECTOR

RECEIVER

CONNECTOR

19.Remove one of the mounting screws from the switch housing plate (Figure 14) and loosen the other two screws several turns.

NOTE: If you are installing an Emerson Light Fixture with your fan, refer to the Light Fixture Owner’s Manual and proceed as follows. Remove the center screw from the switch housing and install the light fitter in the threaded hole. Connect the blue wire from the light fitter to the receiver blue wire, and the white wire from the light fitter to the receiver white wire.

20.Remove the protective paper from the three adhesive blocks in the switch housing.Then posi- tion the remote control receiver securely onto the three adhesive blocks, making sure the antenna wire is uncoiled in the switch housing.

21.Engage the two slots in the switch housing with the two loosened mounting screws in the switch housing plate (Figure 15). Rotate the switch housing to the right, then tighten the two mount- ing screws and install the other mounting screw previously removed in Step 19.

MOUNTING

SCREW (3)

SWITCH

HOUSING

CENTER

SCREW

Figure 15

	REMOTE CONTROL
Figure 14	RECEIVER	8