PIN
HANGER
BALL SETSCREW
DOWNROD
CEILING COVER
CEILING
AT LEAST
7'
Figure 5
Figure 7
FLOOR
5.Reinstall the hanger ball (Figure 5) on the downrod as follows. Route the two 80” motor leads through the hanger ball. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin. Securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
!WARNING
It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are proper- ly installed could result in the fan falling.
6.Screw in four 40-watt (maximum) candelabra base lamps in the housing sockets (Figure 6). Grasp the sockets and pivot them until the lamp bulbs are even with the outer edge of the housing as shown. This will provide the optimum lighting effect.
!WARNING
The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs.
!WARNING
To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked acceptable for fan support, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician in in doubt.
8.Securely attach the hanger bracket to the outlet box using the two screws supplied with the outlet box. (Figure 8.)
!WARNING
Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.
TOP ALIGN WITH
OUTER EDGE OF
THE HOUSING
SOCKET |
|
Figure 6 | CANDELABRA |
BASE LAMP |
7.The fan comes with black and white leads that are 80” long. Before installing fan, measure up approxi- mately 6 to
!WARNING
The fan must be hung with at least 7' of clearance from floor to blades (Figure 7).
6
| OUTLET |
| BOX |
TWO SCREWS |
|
SUPPLIED WITH | HANGER |
OUTLET BOX | |
| BRACKET |
Figure 8 | TAB |
|
9.Carefully lift the fan and seat the hanger ball/down- rod assembly on the hanger bracket that was just attached to the outlet box (Figure 9). Be sure the groove in the ball is lined up with tab on the hanger bracket (Figure 8).
!WARNING
Failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard.
!WARNING
To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and hanger bracket.