Emerson CF945AB, CF945WB, CF945PW, CF945HTW owner manual Unpacking Instructions

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One 1/4” blade screwdriver	One wire stripper
Three wire connectors (supplied)

MATERIALS

1.Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

2.A 9-volt alkaline battery is required for operating the remote control.

3.Four 40-watt (maximum) candelabra base lamps are required for the uplights.

!WARNING

Before assembly your ceiling fan, refer to instructions on proper method of wiring your fan (page 6). If you feel you do not have enough wiring knowledge or experi- ence, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Company. Substitution of parts or acces- sories not designated for use with this product by Emerson Company could result in personal injury or property damage.

1.Check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor assembly

b.One switch housing

c.Five fan blades

d.One ceiling cover

e.Five blade flanges

f.One remote control transmitter

g.One remote control receiver

h.One hanger ball/downrod assembly

i.One hanger bracket

j.One coupling cover

k.Three rod assemblies

l.One rod support assembly

m.One 18” downrod

n.One loose parts bag containing:

1.Sixteen 3/16-24 x 3/8” slotted washer head blade screws

2.Sixteen plastic washers

3.Eleven 1/4-20 x 1/2” flange screws

4.Three wire connectors

5.Two threaded studs

6.Two knurled knobs

7. Two lockwashers 3

8.One clevis pin

9.One hairpin clip

10.One 5/64” hex wrench

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retail- er or catalog outlet for replacement before proceeding.

2.Remove the fan motor assembly from the protective plastic bag and place it into the lower foam pad with the top of the fan motor assembly facing up.

The lower foam pad serves as a holder for the fan during assembly.

	FAN MOTOR
	ASSEMBLY
	HANGER BALL/
	DOWNROD
LOOSE	ASSEMBLY
PARTS	COUPLING	HANGER
BAG
	COVER
		BRACKET
BLADE
FLANGES
ROD SUPPORT		SWITCH
ASSEMBLY	CEILING
	COVER	HOUSING
REMOTE		REMOTE
		CONTROL
CONTROL		RECEIVER
TRANSMITTER

18" DOWNROD ROD ASSEMBLY (3)

FAN

BLADES