NOTE: CEILING COVER, |
| |
SUPPLY WIRES AND | OUTLET | |
FAN WIRES OMITTED | ||
BOX | ||
FOR CLARITY. | ||
|
| HANGER |
| BRACKET |
Figure 9 | HANGER BALL/ |
| DOWNROD ASSEMBLY |
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
!WARNING
To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. NOTE: If you are not sure if the outlet box is ground- ed, contact a licensed electrician for advice, as it must be grounded for safe operation.
12.Screw the two threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 10).
13.Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 11).
14.Secure the ceiling cover in place by sliding lockwash- ers over the threaded studs and installing the two knurled knobs (supplied) (Figure 11). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling.
CEILING COVER
THREADED STUD 
LOCKWASHERS (2)
KNURLED KNOB 
Figure 11
10.Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the grounding conductor of supply (this may be a bare wire or wire with green colored insulation). Securely connect wires with wire connector supplied. (Figure 10).
11.Securely connect the fan motor white wire to the supply white (neutral) wire using wire connector supplied (Figure 10). Securely connect the fan motor black wire to the supply black (hot) wire using wire connector supplied (Figure 10). After connections have been made, turn leads upward and carefully push leads into the outlet box.
WHITE SUPPLY 
(NEUTRAL)
BLACK SUPPLY (HOT)
!WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
15.Mount blade flanges to fan blades using three
PLASTIC WASHER (3)
BLACK FAN 
WIRE
SUPPLY
GROUND WIRE 
GREEN WIRE (GROUND) FROM HANGERBALL
GREEN WIRE (GROUND) FROM HANGER BRACKET
LISTED WIRE
CONNECTOR (3) 
WHITE
FAN WIRE
HANGER
BRACKET
THREADED
STUD (2)
FAN BLADE
BLADE
FLANGE
Figure 12
Figure 10
!WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
NOTE: Take care not to scratch fan housing when installing blades.
NOTE: Remove and discard the four shipping spacers and screws from the motor hub.
7
