Tool Rest | Tailstock | |
|
|
|
|
|
|
Install the tool rack brackets and the tool rack base onto the guide rails using the hex bolt (M12- 1.75 x 65), washer and handle. See Figure 3.
Figure 3. Tool rack mounted to guide rails.
The tool rest fits into the tool rack shaft and is tightened in place with a setscrew (M6-1 x 8). The tool rack shaft drops into the tool rack base and is secured with the tightening knob as shown in
Figure 4.
Figure 4. Tool rest mounted in bracket.
The tailstock rests on the guide rails and is held in place by the tailstock bracket using a double end screw (M12-1.75 x 65), washer and handle. The tailstock can be adjusted along the length of the guide rails to accommodate various lengths of wood stock. There are two ways to adjust the tail- stock. The handle located under the lathe bed can be loosened, allowing the tailstock to slide up and down the length of the guide rails; or the hand wheel can be loosened, allowing the threaded spindle to move back and forth in the tailstock for fine adjustment. See Figure 5.
Figure 5. Tailstock mounted to guide rails.
Live Center
The live center is installed by inserting the end of the shaft into the tailstock assembly. While hold- ing in place, turn the handwheel on the tailstock clockwise until snug.
|
|
|
|
|
|
|
|
|
| G8690 Variable Speed Wood Lathe | |
|
|