SECTION 2: CIRCUIT REQUIREMENTS
110V Operation
The Model G8690 is wired for 110/120V, single- phase operation only. The 1⁄3 HP motor will safely draw 3.1 amps at 110V. If you operate this machine on any circuit that is already close to its capacity, it might blow a fuse or trip a circuit breaker. However, if an unusual load does not exist and a power failure still occurs, contact a qualified electrician or our service department.
The lathe comes equipped with its own fuse rated at 3.15 amps. Never replace the fuse with one rated higher than 3.5 amps.
This equipment must be grounded. Verify that any existing electrical outlet and circuit you intend to plug into is actually grounded. Under no cir- cumstances should the grounding pin from any
Extension Cords
If you find it necessary to use an extension cord with the Model G8690, make sure the cord is rated Hard Service (grade S) or better. Refer to the chart in the standard safety instructions to determine the minimum gauge for the extension cord. The extension cord must also contain a ground wire and plug pin. Always repair or replace extension cords when they become worn or dam- aged.
Grounding
In the event of an electrical short, grounding reduces the risk of electric shock by providing a path of least resistance to disperse electric cur- rent. This tool is equipped with a power cord hav- ing an
G8690 Variable Speed Wood Lathe
Figure 1A Do not remove grounding pin.
Figure 1. Typical 110V |