SECTION 4: OPERATIONS
Operation Safety
Using this machine without proper protec- tive gear could result in damage to your eyes, lungs, and ears. Always wear safety glasses, a respirator, and hearing protection when operating this machine.
Tie back long hair, roll up long sleeves and remove loose clothing, jewelry or gloves to avoid being pulled into moving parts.
NOTICE
If you have never used this type of machine or equipment before, WE STRONGLY REC- OMMEND that you read books, trade maga- zines, or get formal training before begin- ning any projects. Regardless of the con- tent in this section, Grizzly Industrial will not be held liable for accidents caused by lack of training.
H2669 Hobby Lathe
Operations
The Model H2669 Hobby Lathe will perform many tasks, including spindle and faceplate turning as well as disc sanding.
This section will guide you through setup for a typical spindle turning application.
To setup for spindle turning:
1.DISCONNECT THE ELECTRIC DRILL FROM THE POWER SOURCE.
2.Mark both ends of your workpiece by draw- ing diagonal lines from corner to corner. The intersection point of these lines will show you the center of your workpiece. See Figure 11 for details.
Note: 24" is the maximum length of stock you can turn with your hobby lathe and 6" is your maximum end width.
���������
������������
�����������������
��������������
���������
������