Jet Tools JWL-1236 manual Lt Warning

Page 3

Lt WARNING

For your own safety, read this instruction manual before operating the lathe.

Wear eye protection.

Do not wear glQves, necktie, or loose clothing.

Tighten all locks before operating.

Rotate the workpiece by hand before applying power.

Rough out the workpiece before installing on the faceplate. Do not mount a split workpiece or one containing a knot.

Use the lowest speed when starting a new workpiece.

.

.

.

.

.

.

.

.

.

KEEP GUARDS IN PLACE and in working order.

REMOVE ADJUSTING KEYS AND WRENCHES. Form the habit of checking to see that keys and adjusting wrenches are r.emovedfrom the tool before turning it on.

KEEP THE WORK AREA CLEAN. Cluttered,areas and benches invite accidents.

DO NOT USE IN A DANGEROUS ENVIRONMENT. Don'tuse powertools in damp or wet locations, or expose them to rain. Keepwork area well lighted.

KEEP CHILDREN AWAY. All visitors should be kept safe distancefrom the work area.

MAKE THE WORKSHOP KID PROOF with padlocks, master switches, or by removing starter keys.

DON'TFORCE THE TOOL. It will do the job better and safer at the rate for which it was designed.

USE THE RIGHT TOOL. Don'tforce.a tool or attachment to do a job for which it was not designed.

USE THE PROPER EXTENSION CORD. Make sure you extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersize cord will cause a drop in the line voltage resulting in loss of power and overheating. For runs up to 25 feet, use a 18 AWG or larger gauge cord. For runs up to 50 feet, use a 16 AWG or larger gauge cord. For runs up to 100 feet, use a 14 AWG or larger gauge cord. For runs up to 150 feet, use a 12 AWG or larger gauge cord. Runs over 150 feet are not recommended. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.

.

WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neckties, rings, bracelets, or other

 

jewelry which may get caught in moving parts. Nonslip footwear is recommended. Wear protective hair

 

covering to contain long hair.

Image 3 Contents
JET Important Information Lt Warning Tool until it comes to a complete stop Grounding Instructions On-Off Switch Padlock Model No. BP-1, Stock No SwingOverBed Uncrating and Clean-Up Contents of Shipping CartonTools Required for Assembly FIG-1 AssemblyControls ~c -- ~DNomenclature and Use Adjusting Tool RestCentering the Work Lathe ToolsPosition of Hands Adjusting the Tool RestUsing the Parting Tool Smoothing a CylinderFace Plate Turning FIG-14 57-\ Qty Index Part Size48-2 JWL1236-48-2 Set Screw Serial #6105922 andlowerElectrical Schematic