Uncrating and Clean-Up

Note: Uncrating and assembly will require two people due to the machines size and weight.

1.Finish removing contents from the shipping crate. Be sure to check crate thoroughly for any parts not found on initial unpacking.

2.Inspect contents for shipping damage and report any damage to your distributor.

3.Clean all protected parts with kerosene. Do not use gasoline, paint thinner, or any other cellulose-based solvent. These will damage painted surfaces and melt plastic.

Contents of Shipping Carton:

1 - Lathe bed wi motor and tailstock

1 - Tool rest wi extension

4 - Stand legs

2 - Long stand braces

2 - Short stand braces

2 - Stand tops

1 - Bed extension

1 - Face plate

1 - Drift rod

1 - Live center

1 - Spur center

2 - Index pins

1 - Face shield

1 - Hardware package (nuts, bolts, etc.)

1 - Operator's manual

1 - Warranty card

Tools Required for Assembly

NO.1 cross point screwdriver

NO.1 flat blade screwdriver

Hex wrench set

Adjustable wrench or combination wrench set

Use of sockets and a ratchet will speed stand assembly but are not required.

_. -_.'.

".- --

-'--"--

- - -.,--

- - -