Rail Assembly (optional accessory)
1.Attach the front rail (A, Fig. 8) to the cast iron table with two 1/4” x 5/8” hex cap bolts, two 1/4” lock washers, and two 1/4” flat washers. Bolts should be in approximately the center of the slot. Hand tighten only at this time.
2.Attach the rear rail (B, Fig. 8) to the table with two 1/4” x 5/8” hex cap bolts, two 1/4” lock washers, and two 1/4” flat washers. Bolts should be in approximately the center of the slot. Hand tighten only at this time.
3.Push the front, and rear rails up as far as they will go.
4.Tighten the four hex cap bolts holding the front, and rear rails to the table. Do not over tighten the bolts.
5.Attach the guide tube (C, Fig. 8) to the front rail with five 1/4” x 5/8” hex cap bolts, five 1/4” lock washers, and five 1/4” flat washers. Bolts should be in approximately the center of the slot.
Fence Assembly and Adjustment (optional accessory)
1.Attach the fence (D, Fig. 9) to the fence body (E, Fig. 9) with four 5/16” x 3/4” hex cap bolts, four 5/16” lock washers, and four 5/16” flat washers.
2.Thread a hex nut (G, Fig. 10) onto the pad’s threaded stud (H, Fig. 10) and insert through the fence and rear hook (I, Fig. 10). Secure in place using a hex nut, lock washer and flat washer (J, Fig. 10).
Note: The hook should be adjusted so that it overlaps the rear rail by approximately 1/8”.
3.Place fence assembly onto the guide tube. The rear hook should engage the rear rail.
11