Assembly and Setup
1.With help from another person tilt the bandsaw just enough to get one set of feet (A, Fig. 1) underneath the base. Line up holes and bolt (B, Fig. 1) through the base into the feet using two hex cap bolts 3/8”- 16x4”, two 3/8” lock washers, two 3/8” flat washers, and two 3/8” plastic flat washers. Repeat for opposite end.
2.Attach the handle (C, Fig. 2) to the handwheel (D, Fig. 2).
Adjusting Blade Tension
1.Disconnect machine from the power source, unplug.
2.Turn blade tension hand wheel (E, Fig. 2)
•As you become familiar with the saw, you may find it necessary to change the blade tension from the initial setting. Changes in blade width, and the type of material being cut will have an effect on blade tension.
•Keep in mind that too little, or too much blade tension can cause blade breakage and/or poor cutting performance.
Adjusting Blade Tracking
WARNING
Disconnect machinefrom the power source!
Never adjust blade tracking with the
machine running!
Failure to comply may cause serious injury!
Note: Blade tracking has been adjusted at the factory. If, however, it is determined that blade tracking needs adjustment:
1. Blade must be properly tensioned before adjusting blade tracking. Make sure upper and, lower blade guides do not interfere with the blade while adjusting the tracking.
2. Open the upper wheel door. Rotate the wheel forward, and observe the position of the blade on the wheel. The blade should
8
rest in approximately the center of the wheel.
3.If adjustment is necessary, loosen the wing nut (G, Fig. 2) at the top rear of the saw.
4.Adjust tracking by turning the knob (H, Fig.
2)in 1/4 turn increments. Rotate the wheel forward, and observe the position of the blade on the wheel. Rotating knob (H, Fig.
2)
5.Continue with adjustments until the blade is tracking properly.
6.Tighten the wing nut (G, Fig. 2).