Shipping Contents
Remove all contents from the shipping carton. Do not discard the carton or packing material until the band saw is assembled and is running satisfactorily.
Compare the contents of the carton against the list of parts in Contents of Shipping Container (below). The letter identification in the list corresponds to the items shown at right. This is your key for identifying the parts used throughout the Assembly section for easy reference.
Remove the protective coating that is applied to the table with a house hold grease and spot remover.
Contents of Shipping Container
1Band Saw (A)
1Table Insert (B)
1Table (C)
1Miter Gauge (D)
1Fence (E)
1Rail Guide (F)
4Stand Leg (G)
2Short Support Plate (H)
2Long Support Plate (J)
1Owner's Manual (not shown)
1Warranty Card (not shown)
1Hardware Bag (see below for contents)
Contents of Hardware Bag
(p/n
1 Hex Wrench 3mm (K)
1Combination Wrench 10/13mm (L)
4Rail Lock Knob (M)
04 Rubber Foot (N)
01M6x32 Hex Cap Screw (O)
04M6x12 Hex Cap Screw (P)
16M8x16 Carriage Bolt (Q)
20M8 Flat Washer (R)
16M8 Hex Nut (S)
01M6 Hex Nut (T)
04M6 External Tooth Lock Washer (U)
Tools Required for Assembly & Adjustments
The tools listed below are not included but are required for assembly.
214mm Open End Wrench
1Cross Point Screw Driver
1 Combination Square | Shipping Contents |
|
7