Unpacking and Clean-Up
Note: Read and understand the entire manual before attempting setup or operation.
1.Remove all contents form the shipping carton.
2.Inspect contents for shipping damage and report any damage to your distributor.
3.Wipe bed and vise assembly with clean cloth to remove excess oil used to prevent rust.
4.Do not discard any packing material until saw has been assembled and is running properly.
Tools Supplied for Assembly
1. Wrench 12/14mm
Tools Required for Assembly
•#2 Cross Point Screwdriver
•
•Pliers - Regular or Needle Nose
•4mm Angle Hex Wrench
•Ratchet and Sockets will Speed Assembly
Assembly
1.With the help of another person turn the saw over so that it rests on the motor and saw bow, Figure 1. Place it on a piece of cardboard, or a surface that will not damage the saw.
2.Attach a cross brace (A, Fig. 1) to the motor side of the bed using three 5/16”x1” hex cap bolts, six 5/16” flat washers, and secure with three 5/16” hex nuts. Hint: Tighten the nut (B, Fig. 1) on the end of the bed first followed by the nuts on the sides.
3.Attach a leg to the cross brace using four 5/16”x3/4” carriage bolts, four 5/16” flat washers and four 5/16” hex nuts. Use a 12mm wrench to tighten. Repeat for other leg.
4.Remove the brace (C, Fig. 1) on the opposite end of the bed and bow using a 10mm wrench.
5