Guide Roller Adjustment

4.Tighten two hex socket cap screws (A).

5.Repeat for other blade guide assembly.

6.Connect machine to power source.

1.Disconnect machine from the power source.

2.Loosen blade guides (A - Fig. 10) by loosening

screws (B). Slide blade guides away from blade.

3.Loosen locking screws (C) by using a hex wrench.

4.Adjust the eccentric bushings with a combination wrench until the ball bearings are snug to the blade. Note: blade should travel freely up and down between the ball bearings. Do not pinch the blade.

5.Tighten locking screws (C).

6.Slide blade guides back into contact with blade and tighten screws (B).

7.Connect machine to the power source.

Bow Weight Adjustment

Bow weight is one of the most important adjustments of the saw. If the bow weight is not set properly, one can expect poor performance, crooked cuts, tooth stripping, stalling, and the blade popping off the blade wheels. The hydraulic feed rate unit will not compensate for improper bow weight. Bow weight has been set at the factory and should not need any adjustment. If adjustment is necessary:

1.Disconnect the machine from the power source.

2.Turn hydraulic valve to on (F - Fig. 5)

3.Turn cutting pressure control valve (E - Fig. 5) counter-clockwise until it stops.

guideseat

Fig. 10