Always wear approved safety glasses/face

it	WARNING
. Read and understand the entire
	instruction	manual before attempting
.	assembly	or operation.
	All JET bandsaws are designed and
	intended for use by properly trained and
	experienced personnel only. If you are
	not familiar with the proper and safe
	operation of a bandsaw, do not use until
	proper training and knowledge have
	been obtained.
.	Always wear approved safety glasses/face
	shields while using this machine.
.	Make certain the machine is properly
	grounded.
.	Before operating the machine, remove tie,
	rings, watches, other jewelry, and roll up
	sleeves above the elbows. Remove all
	loose clothing and confine long hair. Do
	NOT wear gloves.
.	Keep the floor around the machine clean
	and free of scrap material, oil and grease.
.	Keep machine guards in place at all times
	when the machine is in use. If removed for
	maintenance purposes, use extreme caution
	and replace the guards immediately.
.	Do NOT over reach. Maintain a balanced
	stance at all times so that you do not fall or
	lean against blades or other moving parts.
.	Make all machine adjustments or
	maintenance with the machine unplugged
	from the power source.
.	Use the right tool. Don'tforce a tool or
	attachment to do a job which it was not
	designed for.
.	Replace warning labels if they become
	obscured or removed.
.	Make certain the motor switch is in the OFF
	position before connecting the machine to
	the power supply.

.	Give your work undivided attention. Looking
	around, carrying on a conversation, and
	"horse-play" are careless acts that can
	result in serious injury.
.	Keep visitors a safe distance from the work
	area.
.	Use recommended accessories; improper
	accessories may be hazardous.
.	Make a habit of checking to see that keys
	and adjusting wrenches are removed before
	turning on the machine.
.	Always keep hands and fingers away from
	the blade when the machine is running.
.	Never hand hold the material. Always use
	the vise and clamp it securely.
.	Keep belt guard, blade guards, and wheel
	covers in place and in working order.
.	Always provide adequate support for long
	and heavy material.
.	Use a sharp blade and keep machine clean
	for best and safest performance.
.	Failure to comply with all of these warnings
	may cause serious injury.