•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
WARNING
Read and understand the entire instruction manual before attempting assembly or operation.
These lathes are designed and intended for use by properly trained and experienced personnel only. If you are not familiar with the proper and safe operation of a lathe, do not use until proper training and knowledge have been obtained.
Always wear approved safety glasses/face shields while using this machine.
Make certain the machine is properly grounded.
Before operating the machine, remove tie, rings, watches, other jewelry, and roll up sleeves above the elbows. Remove all loose clothing and confine long hair. Do not wear gloves.
Keep the floor around the machine clean and free of scrap material, oil and grease.
Keep machine guards in place at all times when the machine is in use. If removed for maintenance purposes, use extreme caution and replace the guards immediately.
Do not over reach. Maintain a balanced stance at all times so that you do not fall or lean against blades or other moving parts.
Make all machine adjustments or maintenance with the machine unplugged from the power source.
Use the right tool. Don't force a tool or attachment to do a job which it was not designed for.
Replace warning labels if they become obscured or removed.
Make certain the main power switch is in the OFF position before connecting the machine to the power supply.
Give your work undivided attention. Looking around, carrying on a conversation, and "horse- play" are careless acts that can result in serious injury.
Keep visitors a safe distance from the work area.
Use recommended accessories; improper accessories may be hazardous.
Make a habit of checking to see that keys and adjusting wrenches are removed before turning on the machine.
Never attempt any operation or adjustment if the procedure is not understood.
Keep fingers away from revolving parts and cutting tools while in operation.
Keep belt guard in place and in working order.
Never force the cutting action.
Do not attempt to adjust or remove tools during operation.
Always keep cutters sharp.
Always use identical replacement parts when servicing.
Never operate this machine under the influence of alcohol or drugs.
Failure to comply with all of these warnings may cause serious injury.
3