Receiving, Assembly, Adjustments, Tailstock

Receiving

1.Remove contents from the box.

2.Inspect contents for shipping damage and report damage, if any, to your distributor.

3.Be sure to keep the box and packing material should you need to pack the lathe for moving.

4.Do not clean the lathe with anything other than a damp cloth or a mild solvent. Use of heavy solvents, paint thinner, gasoline, etc. will damage painted surfaces.

Contents of box (Fig. 2):

1 Lathe (A)

1 Knockout rod (B)

910mm Bushings (C)

1Pen mandrel (D)

1Live center (E)

1Spur center (F)

3Chisels – skew, parting, domed scraper (G)

1Goggles

1Owner’s manual

1Warranty card

Assembly

The JPL-358 is fully assembled and comes ready to use right out of the box. However, it is good practice to thoroughly check the tool for loose fasteners, handles, etc. before use.

Four holes are provided in the base of the lathe for bolting it to a table.

Adjustments

Tailstock

Turn handwheel (A, Fig. 3) clockwise to move tailstock spindle forward; counterclockwise to retract tailstock spindle. To lock the spindle, use the lever (B, Fig. 3).

Loosen the tailstock with the attached wrench (C, Fig. 3) and slide tailstock to desired position. Re- tighten with wrench.