Tool Rest
Position the tool rest as close to the workpiece as possible. It should be slightly above the center line of the workpiece.
Loosen the tool rest with the attached wrench (D, fig. 4) and slide tool rest to desired position. Re- tighten with wrench when finished with adjustment.
Adjust the height of the tool rest by loosening the lever (E, Fig. 4). Tighten the lever when finished adjusting. NOTE: The lever is spring loaded; simply pull up on it, rotate it on the pin, and release.
Switch Safety Feature
When the switch is in “off” position, a part of the switch can be pulled out (Fig. 5) to prevent accidental starting of the lathe. The piece must be
Belt Tension
1.To adjust tension of the drive belt, open the cover by turning the knob (A, Fig. 6) clockwise.
2.Loosen the screw (C, Fig. 6) using a hex wrench.
3.Slide the bearing (B, Fig. 6) left to increase tension, right to decrease tension.
Belt Replacement
1.To replace the drive belt, open the cover by turning the knob (A, Fig. 6) clockwise.
2.Loosen the screw (C, Fig. 6) using a hex wrench and slide the bearing (B, Fig. 6) to the right.
3.Remove the old belt and install new one around the pulleys.
4.
7