To set the steady rest:
1.Loosen three hex socket cap screws.
2.Loosen knurled screw and open sliding fingers until the steady rest can be moved with its fingers around the workpiece. Secure the steady rest in position.
3.Set the fingers snugly to the workpiece and secure by tightening three hex socket cap screws. Fingers should be snug but not overly tight. Lubricate sliding points with
Follow Rest
The traveling follow rest (N, Figure 11) is mounted on the saddle and follows the movement of the turning tool. Only two fingers are required as the place of the third is taken by the turning tool. The follow rest is used for turning operations on long, slender workpieces. It prevents the workpiece from flexing under the pressure of the cutting tool.
The sliding fingers are set similar to the steady rest, free of play, but not binding. Always lubricate adequately with
Controls
1.Control Panel: located on front of headstock.
•Coolant
•Power Indicator Light (D, Figure 12) is lit whenever lathe is receiving power.
•Emergency Stop Switch (C, Figure 12) stops all machine functions (Caution: Lathe will still have power). Twist clockwise to
•Jog Switch (B, Figure 12). Quickly press and release to rotate the spindle.
2.Headstock Gear Change Levers (F, Figure 12): Located on front of headstock. Move levers left or right to desired spindle speed.
3.Leadscrew/Feed Rod Directional Lever (E, Figure 12): Located on front of headstock at lower left. Changing knob changes direction of feed.
Do not move knob while machine is running.
4.Feed/Lead Selector Lever (H, Figure 12): Located on front of headstock. Used when setting up for threading or feeding.
Figure 11 (repeated)
Figure 12
16