Woods Equipment VR48A, VR66A Operation, Mandatory Safety Shutdown Procedure, Attaching to Loader

Page 9

OPERATION

The Vibratory Roller is a hydraulically powered attach- ment intended to compact soil, stone, or fill material. The performance of the attachment can vary greatly depending on how it is used and operated. Therefore, the recommended operating procedures in this manual should be followed at all times for maximum productiv- ity.

When attaching the unit to the skid steer, ensure that all hydraulic hoses are coupled securely to the quick couplers.

Prior to operating the attachment, read this entire man- ual. Follow all safety rules in this manual and safety decals on the unit. Make sure that all guards, shields, and decals are in place and in good condition before operation.

MANDATORY SAFETY SHUTDOWN PROCEDURE

Before cleaning, adjusting, lubricating, or servicing this unit, ALWAYS follow the MANDATORY SAFETY SHUTDOWN PROCEDURE:

1.Move the skid steer loader propulsion control lever to the “neutral” position.

2.Shut off the attachment by shutting off the auxiliary hydraulic output.

3.Lower the loader lift arms completely and roll the attachment forward so it is securely resting on firm ground or the shop floor.

4.Engage the loader parking brake.

5.Move the loader throttle to the slow idle position, shut the engine off, and remove the ignition key.

6.Keep the key with you at all times when working on the unit so no one can start the engine without your knowledge.

AARNING

Failure to follow the procedures before clean- ing, adjusting, lubrication, or servicing this unit could lead to serious injury or death.

ATTACHING TO LOADER

See operating instructions in skid steer manual for proper attachment of vibratory roller to skid steer.

Connect hydraulic hoses to auxiliary hydraulic outputs of skid steer.

NOTICE

All hoses should be free of kinks, cuts or abra- sions for safe operation.

Use auxiliary flow only. High flow use can result in motor failure and will void manufacturer’s warranty. See specifications for acceptable flow rates.

TO COMPACT

1.Position the roller by placing roller drum on the ground.

2.Raise the front wheels of the loader 1 to 3 inches (2.5 to 7.6 cm) by lowering the loader arms and rolling the bucket plate out slightly.

3.Engage the loader auxiliary hydraulic circuit.

4.Drive the loader forward slowly.

NOTICE

The drive circuit is bi-directional. For best results, the vibratory axle should spin the direction of the roller axis.

MAN0357 (Rev. 12/10/2007)

Operation 9

 

 

Image 9
Contents Vibratory Roller To the Dealer IntroductionTable of Contents VR48A VR66A VR73A VR84A SpecificationsSafety Rules SafetyInstallation TrainingOperation Storage MaintenanceBe Careful Safety & Instructional DecalsOperation Mandatory Safety Shutdown ProcedureOperation Attaching to LoaderOwner Service Owner ServiceOuter Bearing Replacement Inner Bearing ReplacementHydraulic Motor Seal and Bearing Replacement Bearing InstallationInstall Seal and Bearing Owner Service Dealer Service TroubleshootingSafety Decals Hoses / FittingsParts Vibratory Roller General AssemblyRev /4/2008 MAN0357 Rev /10/2007 Optional Flow Control Kits SAE Series Torque Chart Bolt Torque ChartAppendix Metric SeriesAbbreviations Bolt Size ChartWarranty Woods Equipment Company