Delta SS200 instruction manual Wrench and Blade Storage, Changing Blades

Page 8

WRENCH AND BLADE STORAGE

A convenient wrench and blade holder (A) Fig. 13, is supplied on the left side of the rear casting, which allows you to store the hex wrenches (C), quickset blade changing wrench (B) and extra scroll saw blades when not in use.

CHANGING BLADES

1.DISCONNECT MACHINE FROM POWER SOURCE.

2.Remove table insert.

3.Position blade tension lever (A) Fig. 19, in the vertical position to release blade tension.

4.Insert long end (A) Fig. 14, of quickset blade changing wrench into hole (B) in upper blade holder. This will align wrench (C) with blade holder screw (D).

5.Fig. 15, illustrates the quickset blade changing wrench (E) engaged with the upper blade holder assembly. Turn wrench counterclockwise to loosen screw (D) and remove blade (F) from upper blade holder as shown.

B

C

A

Fig. 13

B

A

D

C

Fig. 14

DE

F

Fig. 15

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Scroll Saw General Safety Rules Additional Safety Rules for Scroll Saws Refer to them often Use them to instruct othersGrounding Instructions Power ConnectionsMotor Specifications Extension Cords Unpacking and CleaningScroll SAW Parts Assembly Illustrates table lock handle I assembled to machineOperating Controls and Adjustments ON-OFF SwitchLocking Switch in the OFF Position Fastening Scroll SAW to Supporting SurfaceWrench and Blade Storage Changing BladesAdjusting Blade Tension Adjusting the Table Tilting the TableAdjusting Holddown Dust BlowerOperations Inside CuttingMaintenance LubricationChoice of Blades Blade BreakageAccessories PARTS, Service or Warranty Assistance Two Year Limited Warranty
Top Page Image Contents