Delta SS200 instruction manual Maintenance, Lubrication

Page 12

MAINTENANCE

LUBRICATION

Perform maintenance below after each 20 hours of use.

1.DISCONNECT MACHINE FROM POWER SOURCE.

2.Remove the four screws (A) Fig. 26, and side panel

(B).

3.Release blade tension by moving blade tension lever to the vertical position.

4.Remove the two pivot bolts and wave washers (C) Fig. 27.

5.Fig. 28 illustrates one of the pivot bolts and wave washers (C) removed. Thoroughly clean grease from shafts of both pivot bolts and lubricate shafts with a few drops of light machine oil.

6.Re-assemble the two pivot bolts and replace side panel. Re-apply tension to the blade.

A BA

Fig. 26

C

Fig. 27

C

Fig. 28

12

Image 12

Contents Scroll Saw General Safety Rules Additional Safety Rules for Scroll Saws Refer to them often Use them to instruct othersPower Connections Motor SpecificationsGrounding Instructions Unpacking and Cleaning Scroll SAW PartsExtension Cords Assembly Illustrates table lock handle I assembled to machineOperating Controls and Adjustments ON-OFF SwitchLocking Switch in the OFF Position Fastening Scroll SAW to Supporting SurfaceWrench and Blade Storage Changing BladesAdjusting Blade Tension Adjusting the Table Tilting the TableAdjusting Holddown Dust BlowerOperations Inside CuttingMaintenance LubricationChoice of Blades Blade BreakageAccessories PARTS, Service or Warranty Assistance Two Year Limited Warranty