Delta 40-540 warranty Leveling the Table, Adjusting Holddown, Adjusting Dust Blower

Page 13

LEVELING THE TABLE

1.Loosen table lock handle way to the right. and move the table all the to the right.

2.Using a square (A) Fig. 33, check to see if the table is 90 degrees to the saw blade, as shown.

3.If the table is not at 90 degrees to the blade, adjust the table accordingly making certain screw (B) Fig. 34, con- tacts bottom of table surface when table is 90 degrees to the blade. Screw (B) can be adjusted by loosening nut (C), thread screw (B) in or out the desired distance and tightnen nut (C).

ADJUSTING HOLDDOWN

The holddown (A) Fig. 35, should be adjusted so it con- tacts the top surface of the work being cut by loosening lock handle (B) and moving holddown rod (C) up or down. Then tighten lock handle (B).

ADJUSTING DUST BLOWER

The dust blower (A) Fig. 36, may be moved to direct air to the most effective point on the cutting line by loosen- ing screw (B), adjust nozzle (A) accordingly and tighten screw (B).

A

Fig. 33

B

C

Fig. 34

B

C

A

Fig. 35

B

A

Fig. 36

13

Image 13
Contents Model Always Wear EYE Protection Safety RulesUnpacking and Cleaning Additional Safety Rules For Scroll SawsCC O Assembly InstructionsPage Page Grounding Instructions Connecting Scroll SAW to Power SourceFastening Scroll SAW to Supporting Surface Locking ON-OFF Switch in the OFF Position ON-OFF and Variable Speed SwitchesTable Insert Changing Blades Adjusting Blade TEN- Sion Tilting the Table Adjusting Clamping Action of Upper Blade HolderAdjusting Dust Blower Adjusting HolddownLeveling the Table Inside Cutting Following a LineChoice of Blade and Speed LubricationBlade Breakage