Delta 36-412 instruction manual Two Year Limited New Product Warranty

Page 22

WARRANTY

Two Year Limited New Product Warranty

Delta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine accessory which in normal use has proven to be defective in workmanship or material, provided that the customer returns the product prepaid to a Delta factory service center or authorized service station with proof of purchase of the product within two years and provides Delta with reasonable opportunity to verify the alleged defect by inspection. For all refurbished Delta product, the warranty period is 180 days. Delta may require that electric motors be returned prepaid to a motor manufacturer’s authorized station for inspection and repair or replacement. Delta will not be responsible for any asserted defect which has resulted from normal wear, misuse, abuse or repair or alteration made or specifically authorized by anyone other than an authorized Delta service facility or representative. Under no circumstances will Delta be liable for incidental or consequential damages resulting from defective products. This warranty is Delta’s sole warranty and sets forth the customer’s exclusive remedy, with respect to defective products; all other warranties, express or implied, whether of merchantability, fitness for purpose, or otherwise, are expressly disclaimed by Delta.

22

Image 22
Contents Dual-Bevel Compound Miter Saw Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionFailure to Follow These Rules MAY Result in Serious Injury General Safety RulesStay ALERT, Watch What YOU are Doing Additional Safety Rules for Miter Saws Power Connections Functional Description Attaching Dust BAG AssemblyDisconnect the Machine from Power Source Moving Cuttinghead to the UP PositionFence Operation Moving Table to the 0 CUT-OFF PositionED E Fastening Machine to Supporting Surface Locking Switch in the OFF PositionOperations Starting and Stopping MachineAdjusting Fence 90 to Blade Adjusting Sliding FIT Between Movable Table and BaseRotating Table for Miter Cutting Table Hazard Zone Disconnect Machine from Power SourceTilting Cuttinghead for Bevel Cutting Disconnect the Machine from the Power Source Adjusting 0, 33.9, and 45 Bevel Positive StopsSelecting 0, 33.9AND 45 Bevel Positive Stops Adjusting the Tension of Cuttinghead Return Spring Adjusting the Bevel LockAdjusting Sliding FIT Between Trunnion and Bevel Bracket Adjusting Sliding FIT Between Cuttinghead ARM and TrunnionTypical Operations and Helpful Hints Adjusting Lower Blade GuardAuxiliary Wood Fence Cutting Bowed Material Auxiliary Fence SpacerCutting Aluminum Constructing Work Support ExtensionsCutting Crown Moulding Using BUILT-IN Stops Cutting Crown Moulding Flat Position Troubleshooting Maintenance Wear Ansi Z87.1 Safety Glasses While Using Compressed AIRChanging the Blade Do not remove the rear guard J FigAccessories ServiceBrush Inspection and Replacement Warranty Two Year Limited New Product WarrantyCanadian PORTER-CABLE Delta Service Centers Michigan