Delta 36-412 instruction manual Moving Table to the 0 CUT-OFF Position, Fence Operation, Ed E

A B C

ED E

Fig. 5 Fig.6

MOVING TABLE TO THE 0° CUT-OFF POSITION

1.Rotate the locking knob (A) Fig. 5 counter-clockwise as far as it will go. Depress the lever (B) and rotate the table

(C) to the 0° straight cut-off position, release the lever (B), and tighten the locking knob (A).

NOTE: This saw incorporates a new slotted plate design feature (D) Fig. 6 with location adjustment screws (E) for fine-adjusting the cutting angle.

2.For proper operation and adjustment of the table, refer to sections, “ROTATING TABLE FOR MITER CUTTING”, and “ADJUSTING SLIDING FIT BETWEEN MOVABLE TABLE AND BASE.”

FENCE OPERATION

The saw is supplied with left and right fence segments (A) Fig. 7 that incorporate a squeeze clamp feature. To operate the fence segment(s) or to slide to another location, squeeze the clamp (B) Fig. 7A & 8A to disengage the lock. Slide the fence to desired location and release to lock the fence. To remove either fence, depress lever (C) and slide it off the fence base. NOTE: The sliding fence segments can be reversed left to right for minimal clearance cutting.

MAKE SURE THAT THE FENCES ARE CLEAR OF THE GUARD AND BLADE BEFORE USING SAW.

B

C

A

Fig. 7 Fig.7A

A

B

C

Fig. 8 Fig. 8A

9