Delta 36-255L instruction manual Attaching Dust BAG

4.Attach the fence slide support (E) Fig. 7D, to the extension table (B) by using the two 5/16-18 x1 1/4” long hex head screws, 5/16” lockwashers and 5/16” flat washers (F). Place lockwasher, then flat washer on screw and bring screws up through the two holes

(G)in table extension and thread them into the two threaded holes (H) on bottom of fence slide support.

H

G

E

NOTE: Do not completely tighten screws at this time.

5.Use a straight edge (C) Fig. 7E, to align the fence slide support (E) with saw fence (J), and tighten the two screws.

6.Position the fence slide (K) Fig. 7F, in position on top of saw fence (J) and fence slide support (E). Slide fence slide (K) back and forth several times to check alignment of fence slide support (E). Make any necessary final adjustments to fence slide support.

7.Remove screw and spring (L) Fig. 7G, and lock handle (M) from locking stud (N).

8.Place 1/4" flat washer (O) Fig. 7G, onto locking stud

(N) and insert locking stud (N) Fig. 7H, through slot in fence slide. Thread locking stud into threaded hole in fence slide support (E).

9.Position lock handle (M) Fig. 7J, on stud and replace screw and spring (L) that were removed in STEP 7. NOTE: Lock handle (M) is spring-loaded and can be repositioned by lifting up on handle.

ML

N

O

Fig. 7G

N

E

Fig. 7H

ATTACHING DUST BAG

Depress spring clips (A) Fig. 8, of dust bag (B) and clip dust bag (B) over rib of dust chute.

F

B

Fig. 7D

EJ

C

Fig. 7E

J

KE

Fig. 7F

L

M

Fig. 7J

BA

Fig. 8

10