Delta 36-255L Moving Cuttinghead to the UP Position, Moving Table to the 0 CUT-OFF Position

Page 9

MOVING CUTTINGHEAD TO THE UP POSITION

B

1.Pull out cuttinghead lockpin (A) Fig. 4, and move the cuttinghead (B) to the up position.

2.Fig. 5, illustrates the lockpin (A) pulled out and the cuttinghead (B) in the up position.

A

MOVING TABLE TO THE 0° CUT-OFF

 

POSITION

Fig. 5

1.Rotate locking knob (A) Fig. 6 counter-clockwise as far as it will go. Depress lever (B) and rotate table (C) to the 0° straight cut-off position, release lever (B), and tighten locking knob (A).

2.Fig. 7 illustrates the table (C) in the 0° straight cut-off position.

3.For proper operation and adjustment of the table, refer to sections, “ROTATING TABLE FOR MITER

CUTTING” and “ADJUSTING SLIDING FIT

C

BETWEEN MOVABLE TABLE AND BASE.”

B

 

A

ATTACHING EXTENSION TABLE AND FENCE SLIDE

1.Attach flat washers to the two 5/16-18 x 3/4” screw assemblies (A) Fig. 7A, and thread into the threaded holes on left side of the saw.

NOTE: Turn the screws only a few threads into the holes at this time.

2.Attach the table extension (B) Figs. 7A and 7B, to left side of saw table, making sure groove of table extension (B) is inside flat washers (C) as shown in Fig. 7B.

3.Use a straight edge (C) Fig. 7C, to make the extension table (B) even with saw table (D), and tighten the two screws (C) Fig. 7B.

B

C

Fig. 6

C

Fig. 7

B

A

Fig. 7A

CD

B

Fig. 7B

Fig. 7C

9

Image 9
Contents Compound Laser Miter Saw Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsImportant Safety Instructions General Safety RulesAdditional Safety Rules for the Laser Additional Specific Safety RulesNever Recut Small Pieces Do not Perform FREE-HAND OperationsPower Connections Foreword Functional DescriptionAssembly Carton ContentsMoving Table to the 0 CUT-OFF Position Moving Cuttinghead to the UP PositionAttaching Extension Table and Fence Slide Between Movable Table and BaseAttaching Dust BAG Operation Locking Switch in the OFF PositionFastening Machine to Supporting Surface Starting and Stopping MachineAdjusting Sliding FIT Between Movable Table and Base Disconnect the Machine from the Power SourceRotating the Table For Miter SAW Cutting Table Hazard Zone Adjusting Fence 90 to BladeTilting Cuttinghead for Bevel Cutting Adjusting Sliding FenceAdjusting Chip Deflector Adjusting 0 and 45 Bevel Positive StopsDisconnect the Machine from Power Source Adjusting the Tension of Cuttinghead Return Spring Adjusting Sliding FIT Between Trunnion and Bevel BracketAdjusting Sliding FIT Between Cuttinghead ARM and Trunnion Adjusting Downward Travel of SAW BladeHOW to Check Laser Alignment HOW the Lasers WorkTo Check for Rotational Alignment To Check for Vertical Alignment To SET Left and Right Kerf AdjustmentAuxiliary Wood Fence Typical Operations and Helpful HintsCutting Aluminum Cutting Bowed MaterialCorrect Incorrect Work Support ExtensionsCrown Moulding Other Angles Brush Inspection Replacement Troubleshooting MaintenanceChanging the Blade Remove Inside Blade FlangeAccessories ServiceWarranty Keep Tool CleanPage Canadian PORTER-CABLE Delta Service Centers