DeWalt 43-460, 43-459 instruction manual Assembly, Attaching Spindle Raising and Lowering Handwheel

ASSEMBLY

For your own safety, do not connect the machine to the power source until the machine is completely assembled, and you read and understand the entire instruction manual.

ATTACHING SPINDLE RAISING AND LOWERING HANDWHEEL

1.Insert the key (A) Fig. 1 into the slot in the spindle raising and lowering shaft (B).

2.Place the handwheel (C) Fig. 1 on the spindle shaft (B). Fit the key (A) into the slot (D) in the handwheel. Firmly tighten the set screw in the handwheel against the key to secure the handwheel to the shaft.

3.Thread the lock knob (E) Fig. 2 into the spindle shaft (B).

ATTACHING EXTENSION WING TO SHAPER TABLE

Attach the extension wing (A) Fig. 3 to shaper table (B) using three 7/16-20 x 1" hex head screws (C) and flat washers (D). Use a straight edge (E) Fig. 3 to level the extension wing with the shaper table before tightening the three screws (C).

	A
	C
B	D

Fig. 1

E

B

Fig. 2

BD

E D

C

D

A

C

Fig. 3

ATTACHING AND CHANGING SPINDLES

DISCONNECT MACHINE FROM POWER SOURCE.

1.Thread one end of the tie rod (A) Fig. 4 into the threaded hole in the bottom of the spindle (B).

2.Insert the tie rod and spindle into the spindle cartridge. Line up the pin (C) Fig. 5 with the notch (D) in the spindle.

3.Thread the nut (E) Figs. 4 and 7 on the bottom end of the tie rod (A).

4.Use a wrench on the flats (F) Fig. 6 to hold the spindle while tightening the nut (E) Fig. 7 on the bottom of the tie rod.

B

A

E

Fig. 4

F

Fig. 6

C

D

Fig. 5

AE

Fig. 7

6