DeWalt 36-255 Adjusting Chip Deflector, Adjusting 0 and 45 Degree Bevel Positive Stops

Page 12

ADJUSTING CHIP DEFLECTOR

1.DISCONNECT THE SAW FROM THE POWER SOURCE.

2.A chip deflector (A) Fig. 22, is supplied to help prevent scrap or cut-off pieces from entering the upper blade guard. The chip deflector (A) should be adjusted so that it is almost touching the side of the blade by loosening screw (B), adjusting chip deflector (A) and tightening screw (B).

ADJUSTING 0 AND 45 DEGREE BEVEL POSITIVE STOPS

B

A

1. DISCONNECT THE SAW FROM THE POWER SOURCE.

Fig. 22

 

2.Adjust saw so that both bevel and miter pointers are set at 0 degrees. Tighten bevel lock handle and lock cuttinghead in down position.

3.Place one end of a square (A) Fig. 23 on the table and the other end against the blade. The blade should be set at 90 degrees to the table.

4.If an adjustment is necessary, loosen bevel lock handle (H) Fig. 24. Loosen locknut (B) and turn adjusting screw (C), with wrenches provided, until blade is 90 degrees to the table. Tighten locknut (B) and bevel lock handle (H).

5.When the blade is 90 degrees to the table, adjust the pointer to line up with the 0 degree mark on the bevel scale.

6.Loosen bevel lock handle (H) Fig. 24, and move cuttinghead all the way to the left bevel position and tighten bevel lock handle.

7.Use a square (A) Fig. 25, to see if the blade is at 45 degrees to the table.

8.If an adjustment is necessary, loosen the bevel lock handle. Loosen the locknut (E) Fig. 26, and turn the adjusting screw (F), with wrenches provided, until the blade is 45 degrees to the table. Tighten locknut (E) and bevel lock handle.

9.These positive stops enable the operator to rapidly position the blade at the most common bevel angles to the table, 90 and 45 degrees.

A

Fig. 23

H

B

C

A

Fig. 24

F

E

A

B

Fig. 25

Fig. 26

12

Image 12
Contents Compound Miter Saw General Safety Rules Additional Safety Rules for Compound Miter Saws Attempt to Repair Power CordReplacement Parts Power ConnectionsMotor Extension Cord SelectionAssembly Moving Table to the 0 Degree CUT-OFF Position Attaching Extension Table and Fence SlidePage Attaching Dust BAG Fastening Machine to Supporting SurfaceStarting and Stopping Machine Locking Switch in the OFF Position Adjusting Sliding FIT Between Movable Table and BaseRotating Table for Miter Cutting Adjusting Fence 90 Degrees to Blade Table Hazard AreaAdjusting Sliding Fence Tilting Cuttinghead for Bevel CuttingAdjusting Chip Deflector Adjusting 0 and 45 Degree Bevel Positive StopsAdjusting Sliding FIT Between Trunnion and Bevel Bracket Adjusting the Tension of Cuttinghead Return SpringAdjusting Sliding FIT Between Cuttinghead ARM and Trunnion Adjusting Downward Travel of SAW BladeAdjusting Blade Guard Typical Operations and Helpful HintsAuxiliary Wood Fence Cutting Aluminum Cutting Bowed MaterialCutting Crown Moulding Constructing Work Support Extensions Brush Inspection and Replacement Changing the BladeKeep Tool Clean Failure to StartPARTS, Service or Warranty Assistance Page Canadian PORTER-CABLE Delta Service Centers