Tooth Breakage | Rough Surface | Rapid Tooth Wear | Vibration |
Band Slips
on Wheel
Troubleshooting Guide
Chip brush not working
–gullets filled
Feed rate too high
Tooth pitch too fine, gullets filled
Tooth shape too weak
Workpiece moves
Band speed too low
Feed rate too high
Tooth pitch too coarse
Band not properly run in
Band worn out
Chip brush not working
Too little coolant Incorrect coolant concentration
Band speed too high
Feed rate too high or too low
Tooth pitch too fine
Wrong tooth shape selection
Band not properly run in
Surface defects, i.e. scale, rust, sand
Guides too far apart Guides poorly adjusted
Band tension too low
Natural vibration – speed slightly high speed slightly low
Feed rate too high or too low
Use Bahco Combo
Band not properly run in
Workpiece not properly clamped
Driving wheel worn out
Band tension too low
Feed rate too high
Band worn out
31