Black & Decker BDCMTJS instruction manual Functional Description

your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.

•Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.

WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or other injury. Always use NOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body.

WARNING: Wear appropriate hearing protection during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.

Symbols

The label on your tool may include the following symbols. The symbols and their definitions are as follows:

V			volts	A		amperes
Hz			hertz	W		watts
min			minutes		or AC	alternating current
		or DC....	direct current	no		no load speed
			Class I Construction			earthing terminal
	.................				..................
			(grounded)		..................	safety alert symbol
	.................		Class II Construction	.../min or rpm...		revolutions or
			(double insulated)			reciprocation per minute
		.............	Read instruction manual before use		..................	Use proper respiratory protection
	.................		Use proper eye protection		..................	Use proper hearing protection

•When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.

			Minimum Gauge for Cord Sets
Volts			0-25	Total Length of Cord in Feet
120V				26-50	51-100	101-150
240V			(0-7,6m)	(7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
			0-50	51-100	101-200	201-300
			(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating				American Wire Gauge
More		Not more
Than		Than	18	16	16	14
0	-	6
6	-	10	18	16	14	12
10 -		12	16	16	14	12
12 -		16	14	12	Not Recommended

Save these instructions

WARNING: Before attempting any of the following operations, make sure the saw blade has stopped, and the battery is removed or the cord is unplugged. Used saw blades can be hot.

FUNCTIONAL DESCRIPTION

1. Jig saw attachment

2

2. Blade clamp4

3. Saw shoe

4. Jig saw blade

1

3

3