Work Piece and Work Area Set Up

7.Loosen the Bolt (112) and make sure that the Swing Guard (53) moves freely back into place before operation.

Depth Adjustment

Lock Ball (25)

Depth Adjustment

Bolt (16)

FIGURE 3

To adjust the depth, turn the Depth Adjustment Bolt (16) shown in FIGURE 3.

1.Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to prevent distraction and injury.

2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.

3.Secure loose work pieces using the vise to prevent movement while working:

Quick	Place Workpiece Here
Release (31)

Vise Handle (28)

FIGURE 4

a. To use the Quick Release (31), put the Quick Release (31) tab in the position shown in FIGURE 4 and push the Vise Handle (28) up against the workpiece. Then tighten the Vise Handle (28).

When releasing, loosen the Vise Handle

(28)a few turns, lift up the Quick Release (31), and pull the Vise Handle

(28)open.

Page 10

For technical questions, please call 1-800-444-3353.

SKU 91938