Chicago Electric 91938 operating instructions Operating Instructions, Tool Set Up

Operating Instructions

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Tool Set Up

To prevent serious injury

from accidental operation:

Release the Trigger, unplug the tool from its electrical outlet and allow the wheel to cool completely before performing any inspection, maintenance, or cleaning procedures.

To Remove or Install a Cut-Off Wheel

1.Raise the Saw if it is locked down by pushing down on it and pulling out the Lock Ball (25).

2.Open the Swing Guard (53) and tighten the Bolt (112) to secure it while working on the Wheel.

	Lock Pin
	(63)
Handle	Fixed
	Guard (60)

FIGURE 1

3.Push the Lock Pin (63) towards the Fixed Guard (60) as shown in FIGURE

1. Rotate the wheel until the Lock Pin

(63) slides into place.

Lock

Pin (63)Socket Head

Bolt (54)

Hex Key

(111a)

FIGURE 2

4.While continuing to hold down the Lock Pin (63), use the Hex Key (111a) to loosen the Socket Head Bolt (54). See

FIGURE 2.

5.Remove the Socket Head Bolt (54), the Flange Washer (96), the Outer Flange (55), and the Cut-Off Wheel (56).

Socket Head

Bolt (54)

Flange

Washer (96)

Outer

Flange (55)

Cut-off Wheel (56)

Inner Flange (57)

6.Replace with a new Cut-Off Wheel (56), and reassemble the parts listed above in number 3. The concave side of the Outer Flange (55) must face the wheel. While holding the Lock Pin (63), tighten the Socket Head Bolt (54) with the Hex Key (111a).

SKU 91938 For technical questions, please call 1-800-444-3353. Page 9