Properlysupportroundmaterialsuchasdowel rods.Theyhaveatendencytorollduringacut, causingthebladeto"bite."Toavoidthis,always usea"v"block.
• Cleareverythingexcepttheworkpiece and
related support devices off the table before plugging into power and turning the saw on.
•PLAN THE WAY YOU WILL HOLD THE WORKPIECE FROM START TO FINISH. Do not hand hold pieces so small that your fingers will go under the work
•BEFORE FREEING ANY JAMMED MATERIAL:
•Turn switch OFF.
•Wait for all moving parts to stop.
•Unplug the saw.
WHEN BACKING OUT OF THE WORKPIECE, THE BLADE MAY BIND IN THE KERF (CUT). THIS IS USUALLY CAUSED BY SAWDUST CLOGGING UP THE KERF. IF THIS HAPPENS:
•Turn switch OFF.
•Wait for all moving parts to stop.
•Unplugthe saw.
•Remove the blade from the blade holders.
•Remove the workpJece with blade from the table.
•Remove blade from workplace.
_i, WARNING: Before removing _oose pieces from the table, turn saw off and wait for all moving
parts to stop to avoid serious personal injury.
,_ WARNING: When servicing, use only identical Craftsman replacement parts. Use of any other
part may create a hazard or cause product damage.
_. WARNING: To prevent accidental starting that could cause possible serious personal injury,
turn off and unplug the saw before maintaining or lubricating your scroll saw.
GENERAL MAINTENANCE
•Keep your Scroll Saw clean.
•After cleaning the table top initially, apply a thin coat of automobile type (paste) wax to the table top so the wood slides easily while cutting.
ARM BEARINGS
See Figure 20.
Lubricate the arm bearings after every 50 hours of use or whenever there is a squeak coming from the bearings.
•Carefully place the saw on its side as shown in
Figure 20. Remove the rubber cap from the lower arm of the saw.
•Squirt a few drops of SAE20 oil around the shaft end and bronze bearing. Let oil soak in over- night, remaining in this position.
Note: Lubricate the upper arm bearing from the other side of the saw.
,_IL WARNING: If the power cord is worn, cut, or damaged in any way, have it replaced
immediately by a quatified service technician at a Sears store to avoid risk of personal injury.
BRONZEBEARING
MOTOR BRUSHES
See Figure 21.
Your saw has externally accessible brush assemblies that should be checked periodically for wear. When one of the two brushes becomes worn, replace both brushes.
•Unplug your saw.
_l, WARNING: Failure to unplug your saw could result in accidental starting causing serious
injury.
19